Tamiya 53713 TB Evolution IV Blue Suspension Mount A OP-713 - Performance Part  [53713]

Tamiya 53713 - TB Evolution IV Suspension Mount A (Blue) OP-713
Price:
NZD$21.58
Brand:
Tamiya
Model:
53713
GTIN:
4950344537136
Condition:
Brand New
Write a review

Upgrading Your TB Evolution IV Suspension

The Tamiya 53713 - TB Evolution IV Suspension Mount A in blue is a practical upgrade for TB Evo IV owners wanting crisper handling. Forged from quality aluminium, the mount increases stability without adding excessive weight.

Why This Mount Helps Control

Specifically matched to the TB Evo IV, the mount's stiff aluminium body and ball link interface help keep suspension motion consistent. That stability improves predictability when driving over bumps and through fast corners.

Quick Installation Notes

Install the mount using the correct fasteners and ensure all joints move freely after tightening. Fine tune link positions and check camber and toe to get the most from the upgrade.

Can I run this on hard-packed tracks?

Yes, the aluminium mount is well suited to firm surfaces where reduced flex helps maintain consistent handling.

Do I need special tools to fit it?

Basic RC tools are enough: hex drivers, screwdrivers and a small torque feel are all you need for a secure fit.

Is any setup change required after fitting?

You may want to recheck suspension geometry and adjust droop or spring rate slightly to suit the firmer mounting points.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved