Tamiya 53726 - 6mm Diameter Shim Set (3 Types, 10pcs Each) OP-726 - Precision Tuning Pack  [53726]

Tamiya 53726 - Dia. 6mm Shim Set (3 Types / 10pcs. Each) OP-726
Price:
NZD$16.00
Brand:
Tamiya
Model:
53726
GTIN:
4950344537266
Condition:
Brand New
Available in warehouse
Write a review

Accurate spacing for 6mm shafts

Getting gear and bearing clearances right is easier with the Tamiya 53726 shim set. The pack supplies 0.1mm, 0.2mm and 0.3mm shims, ten of each, letting you tune shaft play down to small increments.

Useful across different RC platforms

The shims are well suited to hobby projects from drift cars to off-road buggies. Use them to correct mesh, eliminate slop or set bearing preload without replacing core parts.

Reliable Tamiya fit

Produced to consistent tolerances, these shims make repeatable adjustments simple. Keep several layers ready for quick setup changes between tracks or practice sessions.

Will these shims fit bearing spacers on typical RC shafts?

Yes, the 6mm inner diameter matches common bearing spacer shafts that use 6mm sizing, so they can be used as precision washers.

How many shims should I stack before testing?

Stack the minimum number needed to remove play, then test operation. It is often better to add a couple of trial runs than to over stack from the start.

Can I use these on alloy or plastic shafts?

They are suitable for both metal and plastic shaft setups. Ensure edges sit flat and avoid sharp bends when trimming for odd-fit situations.

Do they affect bearing life?

When fitted correctly to remove excessive play without causing preload, these shims can help bearings run more smoothly and reduce uneven wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved