Tamiya 53999 Nitrage 5.2 Aluminum Rear Suspension Mount Plate OP-999 Race-Ready Rear Brace  [53999]

Tamiya 53999 - Nitrage 5.2 Precision Aluminum Rear Suspension Mount Plate OP-999
Price:
NZD$23.93
Brand:
Tamiya
Model:
53999
Condition:
Brand New
Write a review

Rear Mount Upgrade for Nitrage 5.2 Chassis

Hobbyists looking to tidy up rear end feel will find the Tamiya 53999 Precision Aluminum Rear Suspension Mount Plate a useful upgrade for the Nitrage 5.2. Built from strong aluminum, it replaces flexible stock components to give a crisper response under load.

Why a 4mm Aluminum Plate Helps

The Tamiya 53999 uses a 4mm plate, adding 1mm over the typical part thickness. That increase reduces flex where the suspension bolts on, helping the rear end stay neutral and predictable when cornering or powering out of ruts.

Direct Fit and Fast Installation

This rear suspension mount is engineered to fit the Nitrage 5.2 chassis without cutting or drilling. Its accurate hole placement makes the swap quick, making it suitable for tuners at any skill level.

Can I use this mount on other Tamiya cars?

The Tamiya 53999 is tailored for the Nitrage 5.2 and is not guaranteed to fit other models without modification.

Do I need special fasteners?

It typically uses the same screws as the stock mount, though using medium strength threadlocker is recommended for racing use.

Will this change ride height?

The plate keeps factory mounting points, so it does not alter ride height but will stiffen the rear mounting interface.

Is aluminium prone to corrosion?

Anodised or sealed aluminium performs well; rinse after exposure to salt or heavy grime and dry to keep surfaces clean.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved