Tamiya 54448 XV-01 RC Reinforced Drive Belt 573mm OP-1448 - Durable Edition  [54448]

Tamiya 54448 - RC XV-01 Reinforced Drive Belt - 573mm OP.1448 OP-1448
Price:
NZD$15.20
Brand:
Tamiya
Model:
54448
GTIN:
4950344544486
Condition:
Brand New
Write a review

Robust reinforced belt for consistent performance

The Tamiya 54448 XV-01 reinforced drive belt is made to resist wear and cut down friction loss so your setup stays efficient during extended runs. It is a practical choice for racers and club drivers using higher output motors.

Designed for powerful motor setups

Higher power motors generate more torque and heat. This reinforced belt helps maintain drive efficiency under load, reducing chances of slippage and helping the car put power to the ground more predictably.

Direct compatibility with XV-01 cars

Built to the XV-01 belt length and routing, this belt installs without modification on standard XV-01 chassis configurations. Ideal for replacing worn belts or as an upgrade for heavier duty use.

Can I trim this belt to fit another model?

Trimming is not recommended since the reinforcement and tooth profile are tuned for the factory length. Using a non-standard length can lead to poor meshing and premature wear.

What maintenance keeps the belt lasting longer?

Keep belt path free of grit, check pulley alignment, and avoid excessive tension. Inspect periodically after off-road sessions to remove debris.

Is this belt compatible with stock pulleys?

Yes, it is produced to match stock XV-01 pulley profiles and should mesh cleanly with original pulleys when correctly tensioned.

Does belt reinforcement affect noise levels?

Reinforcement can slightly alter tonal characteristics but mainly reduces chatter caused by stretch. Proper tensioning helps keep noise to a minimum.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved