Tamiya 54474 RC DB02 Front Carbon Damper Stay OP-1474 - Lightweight Tuned Plate  [54474]

Tamiya 54474 - RC DB02 Carbon Damper Stay Front OP.1474 OP-1474
Price:
NZD$23.73
Brand:
Tamiya
Model:
54474
Condition:
Brand New
Write a review

Lightweight Carbon Damper for DB-02

The Tamiya 54474 RC DB02 Carbon Damper Stay Front is intended as a direct upgrade to the stock fiberglass reinforced plastic damper stay on the DB-02. Constructed from a 3.5mm carbon fibre plate, it reduces unwanted flex and produces a firmer front end response.

Why Use Carbon Fibre Here

Carbon fibre is valued for its rigidity and low mass, which helps maintain responsiveness without adding unnecessary weight. Swapping to a carbon damper stay can sharpen turn-in and improve track stability when you push harder.

Installation and Maintenance Notes

Replacing the M1 resin parts with this carbon component is straightforward. Make sure screws are seated and tightened evenly to prevent stress concentrations, and give the stay a quick look-over after hitting rough terrain.

Is this compatible with modified DB-02 setups?

It is designed for standard DB-02 geometry. Mildly modified cars often accept the part, but major suspension or chassis alterations might require additional fitting or shims.

Any tips for torque settings?

Use moderate, even torque and avoid overclamping. If possible use a torque driver set to a conservative value to prevent crushing the carbon at the screw seats.

Will it change handling noticeably on rough surfaces?

On rough or bumpy tracks the extra stiffness can make the front end feel more precise, though it may also transmit more feedback to suspension settings, so expect to tweak damping accordingly.

Can I paint the carbon plate?

Painting is possible but use paints compatible with carbon fibre and prepare the surface properly. Keep paint layers thin to avoid adding weight or affecting fitment.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved