Tamiya 54653 - TG10-Mk.2FZ Heat Sink Mount in Blue Anodize  [54653]

Tamiya 54653 - TG10-Mk.2FZ Heat Sink Engine Mount OP-1653
Price:
NZD$28.22
Brand:
Tamiya
Model:
54653
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Keep engine temps in check

The Tamiya 54653 - TG10-Mk.2FZ Heat Sink Engine Mount is aimed at TG10-Mk.2 owners who want more effective cooling. The finned design draws heat away from FS-12FZ, FS-12FX, and FS12FD engines to help maintain consistent performance under load. The blue anodized layer also helps protect the mount from routine wear.

Simple upgrade for better thermal control

Replacing the factory mount with this heat sink option can reduce heat soak on long runs or during repeated hard acceleration. It is a straightforward swap that benefits those running their motors hard.

Form meets function

The anodized blue finish gives a smart appearance while adding corrosion resistance. This mount pairs well with common TG10 component finishes and provides a tidy, functional upgrade point.

Can I use my existing mount screws?

Yes, the heat sink mount uses the same attachment points as the standard TG10-Mk.2 mount, so existing screws and hardware are typically reusable.

Is any break-in needed after fitting?

No special break-in is required. Just install correctly and check clearances and fastener torque before the first run.

Will this affect engine mounting angle?

The mount is designed to match standard TG10-Mk.2 geometry, so engine alignment should remain unchanged when installed properly.

Is the finish resistant to fuel and oil?

The anodized coating offers reasonable resistance to common fuels and oils, but wipe away spills promptly to preserve the appearance.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved