Tamiya 54839 T3-01 Front Fork Springs - Tunable Fork Kit [54839]

Tamiya 54839 - T3-01 Front Spring Set (Soft/ Hard) OP-1839

Price:

NZD$9.64

Brand:

Tamiya

Model:

54839

GTIN:

4950344548392

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Tamiya - T3-01

Tailor Front End Response on T3-01

The Tamiya 54839 Front Fork Spring Set is a compact upgrade for the T3-01 (Dancing Rider Kit) that supplies both soft and hard springs. Use the set to alter the fork tube behavior so your T3-01 tracks more predictably over gravel, grass, or smooth tarmac.

What You Get with Tamiya 54839

Customizable Suspension: Included are two softer rate springs and two stiffer rate springs to change front-end balance.
Direct Replacement: Built to swap into the original MC9 fork internals on the T3-01 without machining.
Improved Ride Quality: Allows finer control of dive, roll, and steering feel at varying speeds.

How do I install the springs into the T3-01 forks?

Remove the fork caps and old springs, then insert the new soft or hard springs into the fork tube following the original orientation; reassemble and check travel.

Which spring combo is best for rough tracks?

Use the soft springs for rough, bumpy surfaces to keep the wheel in contact with the ground; mix rates if needed to balance left and right response.

Do I need other parts to use this set?

No additional parts are normally required for T3-01 forks, though check your fork seals and shafts for wear before fitting new springs.