Tamiya 69933 2mm Hex Driver Bit - Hobbyist Repair Tool  [69933]

Tamiya 69933 - Hex Screwdriver Bit 2mm
Price:
NZD$17.06
Brand:
Tamiya
Model:
69933
GTIN:
4950344699339
Condition:
Brand New
Available in warehouse
Write a review

Workshop Essential - Tamiya 69933 2mm Hex Bit

The Tamiya 69933 Hex Screwdriver Bit is a compact specialist bit for careful RC servicing. Designed for 2mm hex fasteners, it helps model builders handle tiny screws without slipping or damage.

Durable Build and Wide Compatibility

Made from chromium-vanadium steel, the Tamiya 69933 delivers reliable wear resistance. Its magnetic end mates with the TAMIYA Ratcheting Screwdriver PRO (Item 74152) and is compatible with electric screwdrivers that accept a 6.35mm hex shank.

Practical Tasks for the 2mm Bit

Perfect for trimming, tightening and repeated setup work, the 2mm hex bit is handy for securing servo horns, adjusting linkages and tackling small fastenings during routine checks.

Can I use this bit for model aircraft control linkages?

Yes. If the linkage uses 2mm hex screws, the bit is suitable for precise tightening and minor adjustments.

How should I care for the bit to keep it sharp?

Keep it dry and store it in a toolbox or protective sleeve. Wipe clean after use to prevent grit buildup that can wear the tip.

Does it work with power drivers?

It works with power drivers that accept 6.35mm hex shanks, but use low torque and short bursts to avoid stripping small screws.

Is this bit interchangeable with other Tamiya bits?

Yes, it fits standard 6.35mm hex-compatible holders used by many Tamiya and third-party bit sets.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved