Tamiya 74141 Fine Pivot Drill Bit 1.2mm Crafting Tip 1.5mm Shank  [74141]

Fine hole making with Tamiya 74141

The Tamiya 74141 Fine Pivot Drill Bit features a 1.2mm cutting point and a 1.5mm shank, tailored for model makers who require clean, small-diameter holes. It gives consistent performance for detailed assembly work.

Designed for minimal wobble

Because the cutting flute is narrower than the shank, the bit is less likely to chip and stays straighter in the bore. It is compatible with Tamiya pin vises such as 74050 and 74112 for precise manual drilling.

Suitable surfaces

This bit can be used on common modelling materials including plastics and timber, and will also handle brass and softer metals when used carefully. The finish helps create neat hole edges for accurate fitment.

Simple identification and protection

Each diameter is stamped for quick selection and the kit includes a clear plastic case to protect and organise your small drill bits between projects.