Tamiya 9403917 5X7X7.5mm M08 Spacer - Fine Adjustment [9403917]

Price:

NZD$0.00

Brand:

Tamiya

Model:

9403917

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

R/C General - Shim / Washer

Spacer Precision for M08 Tuning

The Tamiya 9403917 5X7X7.5mm Spacer is made to fit the M08 chassis and assist with accurate setup work. It enables small but important changes to clearance and axle spacing that affect handling consistency.

Reliable Fit for M-Chassis Maintenance

Built to provide dependable spacing, these 5X7X7.5mm shims suit a range of M-Chassis layouts and are handy when performing routine servicing or swapping parts. They give straightforward options for tightening handling without major rebuilds.

Will adding this spacer change ride height?

Depending on where it is fitted, the spacer can alter small amounts of clearance or effective axle spacing. Check measurements after fitting to confirm any ride height change.

Do these spacers work with aluminium hubs?

Compatibility depends on the hub bore and shaft dimensions. If the hub and shaft match the spacer sizing, they can be used together, but always verify fit to avoid binding.

Are special tools required to install them?

No special tools are usually needed beyond standard RC setup tools. Clean mating surfaces and use proper tightening sequence, then test the car to confirm alignment.