Tamiya 95186 Jr HG Carbon Wide Front Plate for ME/MA/VZ/FM-A/AR/Super X/XX/TZ-X chassis  [95186]

Tamiya 95186 - Jr HG Carbon Wide Front Plate (1.5mm) Japan Cup 2026
Price:
NZD$20.05
Brand:
Tamiya
Model:
95186
GTIN:
4950344951864
Condition:
Brand New
Available in shop
Write a review

Jr HG Carbon Wide Front Plate with Japan Cup 2026 Styling - Tamiya 95186

This Jr HG Carbon Wide Front Plate is produced in 1.5mm carbon fiber and carries a Japan Cup 2026 styling. The part uses a practical, workmanlike outline and a purple printed Tamiya logo with Japan Cup lettering. Hole spacing follows the drilling pattern from item 15524 FRP Wide Front Plate for the VZ chassis, preserving standard attachment positions for rollers.

Supplied with small attachment parts, the plate provides a stiff mounting surface to maximise roller stability. Its form also makes it suitable as a brake stay where chassis layout permits. Note that selected bodies or chassis versions might need slight trimming for correct fit.

Care tip: protect the printed areas from solvents and strong cleaners. Use a soft cloth and gentle cleaning agents when required.

Material: Carbon fiber plate

Thickness: 1.5mm

Compatible chassis: ME, MA, VZ, FM-A, AR, Super X, XX, TZ-X

Supported roller diameters: 9mm, 11mm, 13mm, 17mm, 19mm

Includes: HG Carbon Wide Front Plate x1 and small attachment parts

Finish: Purple-printed Tamiya logo and Japan Cup motifs

For advanced builders and collectors seeking a stiff, well-dimensioned front stay with Japan Cup visuals, this plate is a practical choice.

What sequence should I follow to fit this plate to a VZ chassis?

Start by test-fitting the plate to check roller alignment and body clearance, fit the supplied small attachment parts to secure the stay, then install rollers and spacers. Trim minimal areas only if interference is found.

Will common body shells require trimming to use this plate?

Some shells and bumper shapes can interfere with the plate edges. Most adjustments are light trimming around the inner body or bumper mount points. Check fit before final assembly.

Is there a recommended way to clean the purple print before events?

Use a damp soft cloth and mild soap if needed. Avoid alcohol and solvent cleaners that can dull or remove the printed detail. Dry gently after cleaning.

How does this plate affect front-end stiffness and handling?

The 1.5mm carbon construction increases front stiffness compared to thin plastics, which can sharpen turn-in and stabilise roller response. Balance this with suspension and roller choices for desired handling.

Are the included attachments sufficient for a basic roller setup?

The kit includes small attachment parts for mounting. Standard roller shafts, bearings and spacers commonly used on compatible stays are required but not special proprietary hardware.

Do roller choices depend on the body and overall car dimensions?

Yes. The plate supports a range of roller diameters, but final compliance with event limits depends on the whole assembly and selected body shell. Check clearances after mounting.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved