Tamiya 9803071 Dog-Bone Shaft for T3-01 Dancing Rider Trike  [9803071]

Tamiya 9803071 - Dog-Bone Shaft: 57405 Trike T3-01 Dancing Rider
Price:
NZD$17.51
Brand:
Tamiya
Model:
9803071
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

T3-01 Drivetrain Support with Tamiya 9803071

The Tamiya 9803071 Dog-Bone Shaft is made for the T3-01 Trike and suits the Dancing Rider model. It restores consistent power transfer and helps eliminate driveline slack that appears with age or heavy use.

Engineered for Accurate Alignment

This dog-bone shaft is manufactured to align precisely with the T3-01 cups and bearings, helping to maintain smooth articulation. The construction is aimed at resisting normal hobby use so your trike performs reliably over multiple sessions.

Usage and Care

Designed specifically for Tamiya T3-01 chassis, the shaft is a smart option for owners wanting to maintain or refresh their Dancing Rider. Regular inspection and light lubrication at joints will extend service life.

Can I use this dog-bone on other trike variants?

It is specifically intended for T3-01 designs. Other trikes may require different lengths or connector types, so verify fit before attempting to use it on non T3-01 models.

Do I need special tools to fit the shaft?

Basic hobby tools are sufficient: small hex drivers, pliers and a screwdriver for set screws. Hand-tighten and check alignment before a full test run.

How should I maintain the dog-bone joints?

Keep the joints free of grit, apply a light coat of appropriate lubricant, and inspect for wear or deformation after rough sessions. Proper care helps avoid premature replacement.

Is this part suitable for track use and street runs?

Yes, it is suitable for normal track and street use when fitted correctly. For heavy competition or extreme conditions consider more frequent inspections.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved