Tamiya 9804140 Universal Drive Shaft Set for TG-10 44032  [9804140]

Price:
NZD$69.04
Brand:
Tamiya
Model:
9804140
Condition:
Brand New
Write a review

Refine TG-10 Drive with the Tamiya 9804140 Shaft

The Tamiya 9804140 Universal Shaft is a practical enhancement for TG-10 fans looking to tidy up drivetrain behaviour. It helps reduce drivetrain lash and gives a firmer connection between the gearbox and wheels.

What the Shaft Delivers

Engineered to improve transmission smoothness, this shaft lowers wear on related components and gives more consistent handling under load. That makes it useful for both weekend track runs and local events.

Where It Fits and How to Use It

Designed with TG-10 chassis geometry in mind, the 9804140 installs with minimal trimming. Its robust build is suited to both hobbyists and regular competitors who want a reliable replacement for worn stock parts.

Can the 9804140 be used in modified TG-10 builds?

Yes, it commonly suits modified TG-10 setups, though you should verify clearance and spline compatibility if other drivetrain changes are present.

Is any setup needed after fitting the shaft?

After installation check alignment and endplay, and run the car at low speed to confirm there are no binding points before full-power runs.

Does the shaft require special lubrication?

Use light grease on joints and ensure supporting bearings are clean and lightly oiled; heavy grease can attract grit and lead to wear.

Will this reduce drivetrain maintenance?

It can lower frequency of part swaps by reducing wear, but routine inspection is still important to catch any developing issues early.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved