Tamiya 9804679 Aluminum Gear Differential Joint Short/Long for TRF417V5  [9804679]

Tamiya 9804679 - Aluminum Gear Differential Joint (Short and Long) For 42240 TRF417V5
Price:
NZD$25.16
Brand:
Tamiya
Model:
9804679
Condition:
Brand New
Write a review

Precision aluminium differential joints for TRF417V5

RC tuners looking to refine their TRF417V5 can use the Tamiya 9804679 aluminium gear differential joint, which comes in both short and long forms. These choices make it easier to adjust gear spacing and fine tune your car's traction balance.

Where it fits

The part is produced to match the TRF417V5 differential layout, allowing straightforward installation into the original drivetrain. That compatibility supports consistent gear engagement with minimal setup changes.

Why pick aluminium

Aluminium construction brings improved strength compared to plastic and can reduce rotating mass slightly, helping the differential resist deformation under load and extending service life during competitive use.

Will these joints fit other Tamiya differentials?

They are designed for the TRF417V5 and may not fit other models without modification or additional parts; check dimensions before attempting cross-fit swaps.

Are aluminium joints heavier than plastic ones?

Depending on design, aluminium can be slightly heavier but offers greater stiffness and wear resistance; the net effect often improves drivetrain consistency over time.

What setup tips work well with these joints?

Try both short and long options during practice to observe differences in corner entry and mid corner traction; small incremental changes yield the best tuning feedback.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved