Tamiya 9805758 2mm Tuning Washers  [9805758]

Tamiya 9805758 2Mm Washer: 57709
Price:
NZD$0.00
Brand:
Tamiya
Model:
9805758
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fine Tune Your RC with Tamiya 2mm Washers

The Tamiya 9805758 2mm Washer is a small but useful item for model builders looking to dial in clearances and improve handling stability. These washers give you repeatable spacing for suspension pivots, motor shims and gear stacks.

Wide Compatibility Across Models

From touring cars to 1/10 off-road rigs, these Tamiya 2mm washers are versatile for many mounting points. Their consistent thickness helps retain proper alignment across repeated servicing and upgrades.

Maintenance and Upgrade Applications

When swapping parts or tweaking setups, the correct washer size prevents over-tightening and unwanted friction. Use the Tamiya 2mm Washer when adjusting ride height, setting gear mesh or securing bearings.

Will these washers affect bearing preload?

A single 2mm washer can alter preload if used next to a bearing. Check bearing play after fitting and adjust shims as needed.

Are these suitable for lightweight builds?

Yes, they are suitable for lightweight and standard builds since they add minimal mass while providing precise spacing.

How do I confirm the washer inner diameter fits?

Measure the fastener or shaft you will use and compare it to the washer bore; if the fit is snug without excess wobble, it will work fine.

Can I use these washers in my gearboxes?

Yes, they can be used to set gear spacing, but always verify gear mesh and ensure no binding occurs after installation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved