Tamiya 9808200 Classic Buggy 3x8mm Shim  [9808200]

Tamiya 9808200 3X8Mm Spacer: 58517
Price:
NZD$0.00
Brand:
Tamiya
Model:
9808200
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Dial in Chassis Geometry with Tamiya 9808200

If you want repeatable spacing when tuning a classic buggy, the Tamiya 9808200 3x8mm Spacer helps set exact clearances between rotating and load bearing parts. Its consistent size makes it a handy item when adjusting ride height, wheel offset, or gearbox spacing. Reliable for both one-off repairs and incremental setup changes.

Consistent Fit for Vintage Parts

This Tamiya 3x8mm spacer is aimed at hobbyists who value repeatable assembly. The spacer reduces unwanted movement between components and supports longer service intervals when paired with proper lubrication and bearing care. Keep a selection of shims when modifying or restoring older models.

Can I use this spacer with non Tamiya parts?

Yes, the spacer can work with other brands if the dimensions match your shaft and bore sizes. Always check fitment and clearances before final assembly to avoid binding.

How many spacers might I need for a typical setup?

The number depends on your chassis and component stack-up. Keep several on hand to test different offsets during setup until you achieve the desired alignment and handling balance.

Will this spacer affect bearing life?

When used correctly to eliminate lateral play, spacers can reduce uneven load on bearings and extend life. Ensure they do not introduce side loads or misalignment which could have the opposite effect.

Any tips for fitting these spacers?

Fit them one at a time and check free spinning of shafts after each change. Mark setups that work so you can repeat them later during maintenance or rebuilds.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved