TAMIYA BBX BB-01 Front Swing Arm Reinforcement 7075 Aluminium BBX008 by GPM  [BBX008]

Front arm code upgrade for BBX BB-01

This aftermarket front arm code fits the 1/10 TAMIYA BBX BB-01 chassis and is supplied as model BBX008. It is intended to replace the stock component at the front swing arm location to give a firmer load path where the arm meets the suspension.

Made from 7075 aluminium, the unit is sized for hobby-grade RC use on the listed chassis. The write-up concentrates on fit and setup effects rather than looks, explaining how swapping to a metal arm code influences front-end behaviour compared with the original part.

Installation requires removal of the original front arm code and installation in the same mounting position using the BBX BB-01 mounting holes. After fitting, verify wheel alignment and suspension travel, and check for contact with steering linkages before running.

An uncomplicated 7075 aluminium swap for BBX BB-01 owners wanting a firmer front arm interface; always confirm chassis compatibility prior to purchase.