This set of aluminum rear suspension arms serves as a scale replacement for Blitzer Beetle series cars, covering Stadium Blitzer and Stadium Thunder. Finished in gun-metal, the arms are intended to take the place of stock plastic components when a firmer, more durable pivot point is required without changing chassis geometry.
Use and fitment: manufactured for 1/10-scale Blitzer-series Tamiya platforms, these arms function as direct hop-up replacements to stiffen the rear pivot and modify chassis reaction under power and over bumps. Verify fitment on your specific vehicle as minor variations in hinge-pin or tower setups can need small tweaks.
Installation guidance: remove the standard rear arms and check hinge-pin bores and mounts for wear. Install the aluminum arms in the original orientation, confirm hinge-pin alignment, and ensure suspension travel is unchanged. Tighten fasteners in stages to avoid binding and perform a short test run to validate alignment.
Tuning notes: stiffer aluminum mounts reduce flex at the rear, which can alter traction and throttle response. If the car feels unsettled in fast transitions, try slightly firmer rear damping or small adjustments to roll center to restore balance. Match shock rates and lengths to the new mounts for best performance.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved