TAMIYA CC-01 Drive Shaft for Amarok 138-145mm SCC037SAAL by GPM  [SCC037SAAL]

Centre prop shaft for CC-01

This centre drive shaft is built as a drop-in replacement for TAMIYA CC-01 chassis, intended for Volkswagen Amarok projects with a 267mm wheelbase. The design uses steel and aluminium to give wear resistance at load points while limiting unnecessary weight, with a length adjustment range of 138mm to 145mm to handle small mounting differences.

The aluminium main tube accepts anodised finishes for colour customisation, and the steel sections reinforce torque transfer locations. The overall profile keeps the original gearbox alignment intact and aims for reliable drivetrain service.

Fitting is routine for hobbyists experienced with CC-01 layouts: swap the unit for the stock centre shaft and mate it to the original parts. Only common hex drivers are typically needed; check spline fit and rotational freedom during setup to prevent binding.

Choose this shaft when replacing a tired centre drive or when you need a modest length adjustment for CC-01 Amarok builds; confirm spline alignment and lightly grease mating surfaces for smooth operation.