TAMIYA CC01 Gear Ratio Kit 59T Spur with 13T & 16T Pinions - CC100MG by GPM  [CC100MG]

Purpose and fitment notes

The CC100MG gear set is presented for use on TAMIYA CC01 models and specifies a 59-tooth spur plus the 13T and 16T pinion options shown in the title. The focus is on how the set integrates with the CC01 drive train and on practical setup guidance rather than material claims.

This replacement spur and pinion listing gives two pinion sizes so you can alter final drive ratio for different track or trail conditions. Use the lower tooth count for stronger pull and the higher count to favour top speed, considering your motor and ESC setup.

Fitment advice: verify mesh with your motor mount spacing, fasten the pinion per your motor's instructions, then rotate the gearbox manually to ensure gears run freely. If you detect binding or too much play, correct mesh with small shims or slight motor repositioning.

For CC01 builders wanting the spur and two pinion choices listed, this set delivers the named tooth counts to alter gearing; always confirm mesh and clearance during installation.