Tamiya CC01 Steel Drive Shaft Adjustable 143mm-168mm SCC037L by GPM  [SCC037L]

Adjustable centre shaft for CC01 builds

This centre drive shaft suits the Tamiya CC01 chassis and carries the model number SCC037L. Constructed in steel, the shaft spans a usable length from 143mm to 168mm and is intended as a direct-replacement or trimmed option for CC01 drivetrain maintenance and upgrades.

Swap to this shaft when the original component shows wear or too much flex; a steel shaft reduces twist under load and improves longevity. The centre drive transmits engine or motor torque to the axles, so material and fit influence how the rig delivers power.

Fitting advice: inspect the spline and coupler ends before installation, set the shaft to the correct trimmed length within the 143mm-168mm range, and confirm straight alignment to minimise binding. Replace any worn U-joints or bearings during the service to maintain smooth operation.

A practical steel upgrade for CC01 drivetrains, offering improved stiffness and service life when matched to the correct length and couplings.