Tamiya CC-02 Aluminum Pivot Link Mount — JR-CC206-RD (upgrade) by JAZRIDER  [JR-CC206-RD]

Tamiya CC-02 Chassis Aluminum Chassis Pivot Link Mount (Red)
Price:
NZD$11.31
Brand:
JAZRIDER
Model:
JR-CC206-RD
Condition:
Brand New
Available in shop
Write a review

Heavy-duty aluminum pivot mount for CC-02

This aluminum pivot link mount replaces the stock plastic piece on the Tamiya CC-02 chassis and is referenced as JR-CC206-RD. It offers a metal option for hobbyists who prefer reduced flex at the linkage pivot points and a more durable mounting surface.

Fitment notes: the component is intended to align with original CC-02 mounting bosses and holes. Before fitting, compare the part to the original to confirm hole spacing and pivot geometry. Use the recommended fastener engagement and re-check link articulation after tightening.

Performance and caution: installing an aluminum mount will stiffen the pivot connection and may shift load paths to adjacent components. This can aid in tuning for responsiveness but may also transmit extra stress to plastic brackets; inspect mating parts and re-tighten hardware after initial runs.

Is special hardware required to install this part?

Typically the original CC-02 screws are compatible, but check thread length and head clearance. Replace damaged fasteners and use lock-tight where appropriate.

Should I expect faster wear on plastic parts?

Because the mount is stiffer, adjoining plastic pieces can see higher load concentration; inspect these areas periodically and consider reinforcing if signs of stress appear.

Does JR-CC206-RD change suspension geometry?

The mount is a direct replacement so geometry should remain unchanged, but the reduced compliance can alter dynamic behaviour under articulation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved