Tamiya CC-02 Chassis Servo Mount Upgrade for Front Brace - JR-CC201-BK by Jazrider  [JR-CC201-BK]

Tamiya CC-02 Chassis Aluminum Front Brace Servo Mount (Black)
Price:
NZD$12.90
Brand:
JAZRIDER
Model:
JR-CC201-BK
Condition:
Brand New
Available in shop
Write a review

Front brace upgrade with servo mounting for CC-02

The JR-CC201-BK replaces the stock plastic front brace on the Tamiya CC-02 with a black anodized aluminum piece that incorporates a dedicated servo mounting point. It is intended to secure the front servo to the chassis more solidly, minimising movement at the mount and preserving steering alignment when the model is under load.

On CC-02 layouts using the factory front servo location the part installs to the existing front brace attachment points and accepts a standard servo in the original position. Make sure to verify servo horn clearance and alignment before final assembly and reuse chassis fasteners where they match. For tuning, adding this aluminum brace decreases front compliance, which can translate to steadier steering when running heavier servos or more aggressive suspension geometry.

Will I need to modify my CC-02 to fit this brace?

No modifications are typically required for standard CC-02 setups; the brace mounts to the factory front brace/chassis points. Always check fit on your specific build before tightening.

Is this part corrosion resistant for off-road use?

The part is aluminum with an anodized black finish, which gives basic surface protection; avoid prolonged saltwater exposure and rinse after muddy runs to preserve the finish.

Can I use my existing servo with this mount?

Yes, the brace accepts standard servo sizes used on CC-02 builds, but confirm horn and cable routing clearance for your specific servo model before final installation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved