TAMIYA CC-02 Rear Chassis Brace Aluminum Reinforcement - JR-CC202-S by Jazrider  [JR-CC202-S]

Tamiya CC-02 Chassis Aluminum Rear Cross Brace (Silver)
Price:
NZD$11.68
Brand:
JAZRIDER
Model:
JR-CC202-S
Condition:
Brand New
Available in shop
Write a review

Aluminum brace built for rear chassis strength

The JR-CC202-S fits the TAMIYA CC-02 chassis as a silver-finished aluminum replacement part. It is intended to provide a more consistent rear structure compared with many stock polymer braces.

Aluminum construction resists deformation better over repeated runs, helping maintain predictable rear-end behavior and reducing variable flex during trail or competition use.

Installation note: the brace is intended to replace the factory rear brace on the CC-02. Installers should use the vehicle's factory mounting points and follow normal tightening and assembly practices to preserve alignment.

Does the JR-CC202-S resist repeated impacts better than plastic?

Yes. Being aluminum, the JR-CC202-S offers increased resistance to permanent deformation versus common plastic braces, which helps with long-term dimensional stability.

Is the silver finish corrosion resistant?

The part is supplied in a silver finish; typical care like keeping it clean and dry will reduce corrosion risk. If you run in wet or salty conditions, inspect and clean the surface more frequently.

Should I change mounting hardware when installing?

In most cases you can reuse the factory fasteners. Check fastener condition and replace any worn or damaged hardware, and follow recommended torque values for the CC-02 rear assembly.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved