TAMIYA CC-02 Suspension Link Arms Upgrade JR-CC2ARM-GU by Jazrider  [JR-CC2ARM-GU]

Tamiya CC-02 Chassis Aluminum Upper & Lower Suspension Link Arms Set (Gun Metal)
Price:
NZD$60.67
Brand:
JAZRIDER
Model:
JR-CC2ARM-GU
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Aluminium link arms built for CC-02 performance

This aluminium upper and lower suspension link arms set fits directly to the TAMIYA CC-02 chassis and carries the JR-CC2ARM-GU model number. Made as an aftermarket RC accessory, the pair replaces stock plastic links with stiffer metal components to reduce flex and stabilise suspension behaviour during technical crawling.

Installing the set affects roll center and anti-squat in predictable ways when used with the CC-02 mounting geometry. Fitment follows standard procedures: remove the factory links, install the aluminium arms in the original locations, and reuse existing pins and bearings when suitable. No chassis trimming is required for compatible mounting slots.

Service is simple: monitor pivot wear, keep mounting pins clean, and verify fastener security after initial runs. The gun metal finish resists visible wear and keeps a low-key appearance, while the aluminium construction prioritises rigidity for tuning stability over impact energy absorption.

Specifications

  • Item: Aluminum upper and lower suspension link arms set
  • Material: Aluminum
  • Model Number: JR-CC2ARM-GU
  • Compatibility: Tamiya CC-02 chassis

If you want more consistent suspension geometry for CC-02 setups, this aluminium link set gives a durable, no-modification upgrade for predictable trail performance.

Are these links more impact resistant than plastic?

Aluminium offers greater stiffness and wear resistance, but it can transmit impact forces differently than plastic. Expect improved geometry control, though very hard impacts may transfer force to other components.

How should I protect the finish in coastal or wet environments?

Wipe down after wet runs, avoid prolonged salt exposure, and apply a light corrosion inhibitor on fasteners if you frequently run near the sea.

Can I reuse the CC-02 bearings with these arms?

Yes, the arms accept standard CC-02 bearings in most builds; inspect bearing fit and replace if play is detected to keep alignment true.

Will the gun metal look wear over time?

The gun metal finish resists surface wear better than raw aluminium and helps hide minor marks, but heavy abrasion will eventually show through like any finish.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved