Tamiya CR-01 Aftermarket Winch CR01-27A by 3Racing  [CR01-27A]

Fitment notes for CR-01 crawlers

The 3Racing CR01-27A is an RC-scale winch built as a hop-up or spare for Tamiya CR-01 based crawlers. It is intended for scale recovery tasks and tidy installations on compact bumpers. Below are fitment guidelines and practical installation tips for CR-01 owners.

Compatibility is centred on the Tamiya CR-01 platform and common CR-01 conversion frames. The winch is sized to match typical CR-01 mounting points and scale bumpers that accept a small winch unit. Always measure mounting dimensions before final fitting.

Installation considerations:

• Check that mounting holes line up with your CR-01 chassis or aftermarket bumper before fastening.
• Route wiring to avoid suspension movement and sharp edges to prevent abrasion.
• Use hardware appropriate for the bumper material and avoid overtightening to protect plastic tabs.

Tuning role:

• Use this as a scale recovery and show item; ensure your servo and drivetrain can handle any extra load introduced when the winch is under tension.
• For motor-driven winches check gear engagement and consider thread locker on mounting screws where vibration is likely.

This winch is a straightforward hop-up for CR-01 scale crawlers, useful for realistic recovery scenarios and neat bumper installs. Verify fit and wire routing for dependable use.