Tamiya CR01 One-Piece Rear Hub 3RACING CR01-19/LB Off-Road Favourite  [CR01-19/LB]

Tamiya CR01 One Piece Rear Hub - 3RACING CR01-19/LB
Price:
NZD$32.52
Brand:
3Racing
Model:
CR01-19/LB
Condition:
Brand New
Write a review

Tidy rear hub solution for Tamiya CR01

The 3RACING One Piece Rear Hub (CR01-19/LB) is a neat upgrade aimed at owners of the Tamiya CR01. It gives a firmer wheel attachment and helps the truck track truer over rough ground without adding complexity.

What this rear hub brings to your CR01

Designed to match the CR01 geometry, the 3RACING hub offers a robust single-piece layout that reduces the number of wear points. That simplicity helps keep maintenance low while preserving reliable performance during trail sessions.

Fitting pointers for a clean install

Before fitting, wipe the axle area free of grit. Position the hub square to the axle and tighten using the proper screws. Periodic lubrication of adjacent moving parts will help the unit last longer and stay smooth.

Can I use this on modified CR01 axles?

Minor axle mods may be compatible, but always confirm dimension alignment first. If the axle diameter or shoulder differs, fitting could be affected.

Does it need special fasteners?

It uses standard mounting screws for the CR01 layout. Use the recommended screw lengths and thread types to avoid interference with bearings or hubs.

Is this good for rock crawling?

Yes, the reduced play from a one-piece hub helps in slow technical sections, giving more predictable response when picking lines on rocks and roots.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved