This front shock tower fits the Tamiya DF01 platform and carries the identifier DF1028. It serves as the attachment point for the front dampers and aligns with DF01 suspension geometry for reliable replacement and setup adjustments.
Designed as a direct replacement, the tower restores the original shock mounting points on DF01 models and provides the load-bearing link between shock units and front uprights. The unit is sold as 1 pcs and is intended for routine maintenance, crash repairs, or small tuning changes that affect leverage and shock angle.
Installation follows the standard DF01 front mount locations; remove the old tower and install this piece in the same orientation. Once installed, verify shock shaft alignment, adjust preload and check ride height because tower position will affect steering feel and front grip.
As an aftermarket spare, this tower is handy for replacing worn or broken front mounts on DF01 cars and for experimenting with minor changes to shock geometry during setup trials.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
