Tamiya DF01 Rear Suspension Arms Upgrade for Top Force and Manta Ray JR-DF102-LB by Jazrider  [JR-DF102-LB]

Precision machined rear arms for DF01 platforms

These aluminum rear suspension arms are a direct-fit accessory for Tamiya DF01-based 1/10 buggies. The machined aluminum body and blue anodized coating provide a more rigid mounting surface than factory plastic parts, which helps limit rear-end flex during high-load maneuvers.

For installation, remove the OEM rear arms and fit the replacements using existing mounting pins and screws where compatible. Verify hinge-pin alignment and confirm there is adequate clearance around drive shafts and shock mounts. These parts are intended as a tuning option to modify rear compliance without altering springs or dampers.

Note: Compatibility is restricted to the DF01 family and the models listed below; do not use these arms on Tamiya RC Cayenna (58406) or Racing Lancer (58421).