TAMIYA DF-02 Universal Swing Shaft 64mm Steel SDF2264C by GPM  [SDF2264C]

Universal 64mm Swing Shaft for the Tamiya DF-02

Aftermarket 64mm steel universal swing shaft made for the TAMIYA DF-02 chassis and supplied as a 1 pr set with washers. The CVD-style layout is intended for direct replacement or routine driveline maintenance on DF-02 models.

This component is shaped to occupy the same position as factory CVD-style swing shafts within the DF-02 gearbox and suspension geometry. Installation normally involves removing the relevant drive-side hardware then inserting the replacement shaft into the existing drive cups and retaining parts, using the supplied washers as needed.

Used in tuning and repair scenarios, the shaft functions as a quick service replacement for worn or damaged parts and as a simple upgrade option where a tougher material is preferable to stock pieces. Always check clearances and cup seating before finalising the build.

Install this shaft as a direct replacement when DF-02 driveline geometry matches, keeping washers and original retention hardware to maintain proper alignment and drivetrain performance.