Tamiya DT02 Titanium Fastener Kit TS-FW06/V1 by 3Racing  [TS-FW06/V1]

Kyosho FW06 Tamiya DT02 Titanium Screw Set - 3RACING TS-FW06/V1
Price:
NZD$66.33
Brand:
3Racing
Model:
TS-FW06/V1
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Precision titanium screws for FW06 and DT02 applications

This titanium screw kit provides scale hardware intended to upgrade or replace smaller fasteners on compatible touring and drift cars. The set targets corrosion resistance and weight saving where strong, low-mass fasteners improve serviceability and handling repeatability.

Role overview: deliver robust, lightweight fasteners for structural mounts and accessory fixings that benefit from titanium properties. Installation uses standard modelling fastener technique with suitable hex drivers and careful torque control to prevent damage to alloy threads or over-compressing plastic parts.

The product listing states compatibility, so apply the screws where head type and thread form match the chassis points listed. Always confirm thread engagement length and clearance when moving from steel to titanium to ensure secure clamping without interference.

Specifications

  • Item: Titanium Screw Set
  • Material: Titanium
  • Model Number: TS-FW06/V1
  • Compatibility: Kyosho FW06, Tamiya DT02

Best used where titanium's corrosion resistance and reduced mass matter for repeated assembly cycles; test fit before full replacement to avoid fitment issues.

How do I confirm fit before swapping all screws?

Select a few representative screws and trial them in non-critical locations to verify thread engagement, head clearance and clamping before replacing every fastener.

Will titanium fasteners change handling?

Reduced unsprung or rotating mass from lightweight hardware can have small effects; on touring and drift cars the primary benefit is durability and corrosion resistance rather than a major handling change.

Which drivers should I use for assembly?

Use the correct size hex driver and finish final seating with a hand tool or torque-limited driver; avoid high-torque power tools for the final turns.

Any special care for titanium screws?

Titanium is corrosion resistant but can gall with some alloys; use proper lubrication on mating threads and avoid mixing with dissimilar materials without appropriate washers or coatings.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved