TAMIYA DT-03 Aluminium 58mm Drive Dog Bone DT3158 by GPM  [DT3158]

Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158
Price:
NZD$19.94
Brand:
GPM
Model:
DT3158
GTIN:
4894538052800
Condition:
Brand New
Write a review
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"
alt="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158" title="Tamiya DT03 Aluminium Dog Bone (58mm) - 1pr set - GPM DT3158"

58mm Aluminium Dogbone for TAMIYA DT-03

This precision machined aluminium dog bone is intended as a drivetrain replacement for the TAMIYA DT-03 chassis and is sold as a 1pr set suitable for 1/10-scale RC cars. It provides a metal alternative to the stock plastic dog bones while being intended only for model use.

Fitment follows standard dog bone replacement for DT-03: remove wheel hubs and driveshaft retainers, slide out the original dog bone, fit the 58mm aluminium piece into the outdrive cups and hub bores, then reassemble and check for correct axial clearance. The part conforms to DT-03 coupling dimensions, so verify clip orientation before running.

Swapping to aluminium changes drivetrain stiffness and wear patterns relative to plastic components; include joint inspection and light lubrication of contact points in your regular maintenance routine to maintain reliable operation.

Is this a direct drop-in for DT-03?

Yes, it is designed for the DT-03 chassis but you should confirm your vehicle uses the standard 58mm dog bone and matching outdrive cups before installation.

Do I need special tools to fit it?

Basic RC hand tools are sufficient: hex drivers, pliers for clips and a small screwdriver to remove retainers. No specialised machining tools are required.

Should I lubricate the dog bone?

Apply a light lubricant to the retention points and keep mating cups clean to reduce wear and noise during operation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved