Track-Ready Red C Hubs for DT-03 by JAZRIDER JR-DT304-RD  [JR-DT304-RD]

Tamiya DT-03 Aluminum C Hub (Red)
Price:
NZD$18.00
Brand:
JAZRIDER
Model:
JR-DT304-RD
Condition:
Brand New
Available in warehouse
Write a review

Upgrade front end strength on your DT-03

The JAZRIDER red aluminum C hub improves the front assembly of the Tamiya DT-03 by swapping fragile plastic parts for a robust metal option. The stiffer hub helps keep alignment steady over rough surfaces.

Why aluminium is a smart upgrade

Aluminium C hubs resist wear and bending that can affect handling. These hubs provide reliable contact points that maintain steering geometry longer than stock plastic pieces.

Simple installation notes

Fitting the JAZRIDER C hubs is straightforward. Use correct sized drivers and confirm the hubs rotate freely before reattaching wheels. The bright red anodise also makes it easy to spot any cracks or hardware issues during inspections.

Do I need to change my bearings or knuckles?

In most cases the bearings and knuckles remain the same. Check fitment as some assemblies may be tight and require light sanding or a different bearing spacer.

Will handling feel different after fitting?

Expect firmer steering response and less flex under load. That translates to crisper turn-in and more consistent behavior across multiple runs.

Any tips for test runs after install?

Start with gentle runs to check for binding, then recheck fasteners and steering slop. Small trim adjustments may be needed to restore your preferred handling.

Can I use these hubs in wet conditions?

Aluminium resists moisture better than raw steel, but avoid salt water exposure. Clean and dry hubs after wet runs and inspect hardware for corrosion.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved