Tamiya DT-03 Aluminum Rear Hub Carrier Upgrade - JR-DT307-LB by Jazrider  [JR-DT307-LB]

Product Details — Rear Carrier

This aluminum rear hub carrier is an RC-scale replacement made for the Tamiya DT-03 chassis. Precision machined and finished in a light blue anodize, it is designed as a direct-fit option to replace the factory rear hub carrier on DT-03 assemblies.

As a structural mounting point for the rear wheel hubs, the carrier affects wheel alignment and suspension geometry. The aluminum option reduces flex under load and offers a firmer rear mounting surface, aiding tuners when dialing in toe and camber settings.

Fitment is simple for those experienced with DT-03 servicing: remove the rear wheel and hub, remove the original carrier, and install this carrier using the existing mounting points and fasteners. After fitting, recheck alignment and clearances prior to operation.

Note: intended for Tamiya DT-03 chassis only. Confirm part compatibility with your chosen wheel hex and axle configuration before permanent installation.