Tamiya DT-03 Red Rear Lower Arm by JAZRIDER JR-DT301-RD  [JR-DT301-RD]

Tamiya DT-03 Aluminum Rear Lower Suspension Arm (Red)
Price:
NZD$26.02
Brand:
JAZRIDER
Model:
JR-DT301-RD
Condition:
Brand New
Available in warehouse
Write a review

Upgrade the DT-03 with Red Aluminium Lower Suspension Arms

The JAZRIDER Tamiya DT-03 Aluminum Rear Lower Suspension Arm in red is an effective replacement for factory plastic arms. Tailored for the DT-03 layout, these aluminium arms improve structural strength and reduce breakage risk during rough running.

Compatibility and Use

These aluminium arms are made to align with the mounting points of the Tamiya DT-03 chassis and act as a more robust alternative to stock components. The metal construction resists wear better under frequent off-road usage and club racing conditions.

Assembly Notes

Ensure all mounting screws are tightened correctly when fitting the aluminium arms and recheck after the first sessions. Routine checks for loosening fasteners will help avoid issues caused by vibration over time.

Can I replace my stock DT-03 arms with JR-DT301-RD directly?

Yes, these are intended as direct replacements for the DT-03 rear lower arms, but you should confirm hole alignment and hardware fit on your specific build before final installation.

Will I need to change my suspension setup after fitting these arms?

In many cases no major changes are required, but check toe and camber after installation. Metal arms can affect flex characteristics, so small trim adjustments may improve handling.

What routine checks should I do after upgrading?

Inspect screws and pivot points after the first run and at regular intervals. Look for any signs of wear or looseness that could change suspension geometry.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved