The JR-DT307-RD aluminum rear hub carrier is an RC-scale replacement intended for the Tamiya DT-03 chassis. Supplied in red, the machined aluminum construction offers superior stiffness compared with stock plastic carriers.
Durability and setup tips: replacing a flexible plastic carrier with this aluminum unit reduces chassis deflection under load and can extend service life when running harder suspension settings. Expect more repeatable suspension behaviour when adjusting ride height and damping.
Fitting notes: follow standard rear hub removal procedures, move bearings or retaining pins across from the original part, and secure the aluminum carrier using the chassis fasteners and the correct driver. Recheck wheel alignment and suspension travel after initial test runs.
Compatibility advisory: listed for DT-03 use; confirm physical alignment before attempting fitment on other Tamiya models. This is an aftermarket RC part, not for full-size vehicles.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
