TAMIYA DT-04 Front C-Hubs 7075-T6 Upgrade DT4019 by GPM  [DT4019]

7075-T6 alloy C-hubs for DT-04

Swap the factory front C-hubs on the TAMIYA DT-04 RC FIGHTER NXGEN for machined 7075-T6 alloy pieces intended for 1/10 DT-04 chassis. The upgrade focuses on reducing movement in the steering geometry so camber and toe remain predictable during set-up changes.

Package hardware (screws and collars) arrives pre-assembled to the hubs to speed installation. GPM advises using a medium-strength thread locking fluid on suspension fasteners after trial assembly to limit vibration loosening while allowing reasonable disassembly.

These anodised hubs are offered in a selection of colours to suit different builds and replace the original plastic or aluminium front C-hubs without changing the DT-04 knuckle or upright mounting faces.

Use these hubs when you need crisper steering feedback and steady alignment during setup; always confirm DT-04 compatibility before final fitting and apply thread locker as recommended.