TAMIYA DT-04 Front Upper Suspension Arm 7075-T6 Lightweight DT4054 by GPM  [DT4054]

7075-T6 aluminium upper arm for DT-04

This front upper suspension arm is produced from 7075-T6 aviation-grade aluminium as an RC-scale replacement for the factory front upper arm on the TAMIYA DT-04 RC FIGHTER NXGEN. The component supports chassis loads, stabilises the front knuckle, and acts as a precise tuning point for handling improvements without implying any real vehicle use.

Designed for impact and wear resistance, the arm receives an anodized finish and is available in sky blue, black, and silver. The small hardware arrives pre-assembled to the arm; apply medium-strength screw glue to the fasteners to help avoid loosening during running.

Part location: front upper suspension arm area; this hop-up replaces the original front upper suspension arm and is intended for 1/10 DT-04 maintenance and tuning work.

Fit this arm to restore correct front geometry or fine tune steering characteristics; confirm listed compatibility and secure screws with medium-strength threadlocker as supplied hardware is pre-assembled.