Tamiya FF02 Aluminium Drive Shaft Upgrade 3RACING FF02-04  [FF02-04]

Tamiya FF02 Aluminium Universal Shaft - 3RACING FF02-04
Price:
NZD$19.77
Brand:
3Racing
Model:
FF02-04
GTIN:
4895124722657
Condition:
Brand New
Write a review

Fit a 3RACING Aluminium Universal Shaft to Your Tamiya FF02

For hobbyists tuning a Tamiya FF02 chassis, the 3RACING Aluminium Universal Shaft (FF02-04) is a sensible upgrade from the factory plastic units. It gives a tougher joint that copes better with repeated running.

Why Choose Aluminium for the Driveline

Aluminium construction reduces unwanted flex and helps the drivetrain preserve alignment under cornering forces. Where plastic shafts can deform and increase slop, an aluminium shaft keeps the Tamiya FF02 running truer lap after lap, which is useful for club racing or practice sessions.

Compatibility Tips and Installation Guide

The shaft is produced to suit the Tamiya FF02 chassis layout and should install cleanly without cutting or altering the chassis. Check that the splines and retaining hardware match during fitment to ensure secure operation.

Can I use this on modified FF02 cars?

Yes, it works with most FF02 configurations, but verify shaft length and joint orientation if you have nonstandard suspension or chassis mods.

Does the aluminium shaft change handling feel?

Drivers will often notice reduced driveline flex and crisper throttle response, which can translate to a steadier corner exit on surfaces like carpet and bitumen.

Are special tools required?

Standard hand tools are usually enough. Keep basic hex drivers and pliers on hand and refer to the chassis layout while fitting to avoid misalignment.

Should I keep the old plastic shafts?

It is sensible to keep the original parts as spares. If you experiment with setup changes, you may want to revert for comparison or use them as backups.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved