Tamiya FF-03 Servo Bay Graphite Plate FF03-21/WO by 3Racing  [FF03-21/WO]

FF-03 graphite servo bay reinforcement

This graphite servo protector is tailored for the Tamiya FF-03 chassis family and is identified as part FF03-21/WO. The thin, rigid plate is intended to protect the servo mounting zone from knocks while adding a measured increase in local chassis stiffness.

Compatibility is confined to FF-03 layout cars; this is an aftermarket hop-up for 1/10 electric touring vehicles and should be treated as reinforcement rather than a replacement structural member.

To install, align the plate over the servo pocket and secure using the FF-03 mounting bosses or the stock fasteners supplied with your model. Standard hex tools used for routine FF-03 work are usually sufficient. Always check that servo leads and the receiver are clear before tightening.

When used as part of a tuning package the protector can prevent direct contact to servo cases during minor impacts and reduce flex in the servo bay, which may result in a steadier steering response when combined with sway bar, damper and servo saver changes. Verify servo dimensions to ensure compatibility with your chosen unit.