TAMIYA Front Suspension Arm Mount & Gearbox Support for Thunder Shot / Thunder Dragon / Fire Dragon / Terra Scorcher - JR-TFD08-LB by Jazrider [JR-TFD08-LB]

Tamiya Thunder shot/ Thunder Dragon/ Fire Dragon/ Terra Scorcher Aluminum Front Suspension Arm Mount/Gearbox Support (A5 Parts) (Blue)

Price:

NZD$14.75

Brand:

JAZRIDER

Model:

JR-TFD08-LB

Condition:

Brand New

Quantity:

Available in shop

Write a review

Description
FAQ

Front arm mount designed for TAMIYA competition buggies

This aluminium front suspension arm mount also serves as a gearbox support, finished in blue anodize and sold as model JR-TFD08-LB. It is presented as a replacement for the A5 front mount on TAMIYA Thunder Shot, Thunder Dragon, Fire Dragon and Terra Scorcher chassis and focuses on increasing front-end rigidity rather than altering primary suspension geometry.

The part is intended to fit the factory front suspension and gearbox locations on the specified TAMIYA kits. Installation normally follows the stock A5 removal and replacement process, using existing mounting points and common RC fasteners; always test fit before completing assembly. No additional parts are supplied.

As an aluminum upgrade this component stiffens the local front bulkhead area and gives a stable mounting surface for the gearbox. That change can affect steering feedback and balance, so tune shock settings and link lengths in small steps while assessing performance.

How do I replace the stock A5 front mount with this part?

Remove the original A5 part following the kit manual, position the new mount aligning the factory holes, then secure with the same mounting hardware. Check alignment and clearances before final tightening.

Are extra screws or spacers required for fitment?

This item is made to use the chassis mounting points and standard RC hardware from the kit; additional screws or spacers are not included and are only needed if your chassis has been modified.