TAMIYA Front Upright Set for WR02 DT03T (Aluminum) JR-WR201-LB by Jazrider  [JR-WR201-LB]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Light Blue)
Price:
NZD$15.42
Brand:
JAZRIDER
Model:
JR-WR201-LB
Condition:
Brand New
Available in shop
Write a review

Durable anodized uprights for WR02/DT03T

This is an aluminum front upright set designed specifically for TAMIYA WR02, DT03T and Blitzer Beetle chassis. The light blue anodizing provides corrosion resistance and a clear visual upgrade without altering factory mounting points, delivered as matched left and right components.

Install this kit when you need a tougher steering pivot than typical plastic uprights. The increased stiffness reduces component movement under load, which helps preserve alignment settings and extends the life of steering linkages during frequent use.

Fitment notes: uprights are produced to align with the standard front assembly attachment locations for WR02/DT03T/Blitzer Beetle. Reuse original suspension pins and bearings where compatible, and verify full range steering and suspension travel after installation to avoid interference.

How do these uprights resist wear compared with plastic originals?

The machined aluminum and anodized finish are more resistant to abrasion and deformation, so they hold geometry better over many runs compared with stock plastic parts.

Should I change bearings or pins when fitting this aluminium set?

No special fasteners are required, but if the existing pins or bearings are worn, replace them to ensure proper fit and to prevent premature wear on the new uprights.

Will the anodized surface need maintenance?

Anodizing is low maintenance; occasional cleaning to remove grit and avoiding harsh chemicals will keep the finish and fitment performing well.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved