Tamiya GT-01 Titanium Camber King Pin Ball Stud GT-11 for Suspension Tuning by 3Racing  [GT-11]

Tamiya GT-01 GT01 Titanium Camber Adjustable King Pin Ball Stud - 3RACING GT-11
Price:
NZD$12.95
Brand:
3Racing
Model:
GT-11
Condition:
Brand New
Write a review

Adjustable titanium stud for GT-01 suspension

The GT-11 camber ball stud is a direct replacement for the stock king pin ball stud on Tamiya GT-01 chassis, using a titanium, adjustable design aimed at model-level suspension setup and precise camber changes.

Use this component where repeatable steering geometry and reduced component flex matter for consistent cornering on sealed surfaces. The adjustable stud allows you to dial static camber and test roll centre settings without removing major bulkhead components.

Installation advice: fits the GT-01 steering knuckle and king pin arrangement. Install with the vehicle's original fasteners, apply thread-lock as recommended, and confirm thread engagement and clearance before full-speed runs.

Can I use this on modified GT-01 setups?

It will fit stock-style knuckles; if you have non-standard modifications check shaft diameter and thread compatibility prior to installation.

Is special maintenance required?

Inspect for burrs and ensure threads remain clean. Reapply thread-lock after major disassembly and check for play during routine maintenance.

Will this change steering feel?

Yes, reducing flex and stabilising camber settings can tighten initial turn-in and make steering more predictable; adjust progressively to find your preferred balance.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved