Tamiya Hotshot & Hotshot II Aluminium Stabiliser Stay Pair (Black, 2pcs) JAZRIDER JR-THS03-BK  [JR-THS03-BK]

Tamiya Hotshot, Hotshot II/2 Aluminum Stabilizer Stay (2pcs) (Black)
Price:
NZD$8.00
Brand:
JAZRIDER
Model:
JR-THS03-BK
Condition:
Brand New
Available in warehouse
Write a review

Improve chassis balance on the Hotshot

The JAZRIDER Aluminum Stabilizer Stay pair is tailored for the Tamiya Hotshot and Hotshot II. These two black aluminium stays increase chassis resistance to roll and give a firmer, more controlled feel when driving over rough surfaces or on loose terrain.

Thoughtful metal design for everyday use

Built from aluminium to keep strength up and weight down, the black coating offers added protection against scuffing. They are a sensible upgrade for club racers and weekend drivers who want consistent handling without heavy parts.

Simple fitment and checks

Compatible with both Hotshot generations, the stays install using common RC toolkit items and do not require cutting or permanent changes to the model. Fit, then confirm clearances before your next run.

Can I use these on older or different Tamiya kits?

They are designed for the Hotshot and Hotshot II specifically. Other Tamiya kits may mount stabilisers differently, so confirm fitment before buying.

Will fitting them change ride height or handling setup?

These stays alter roll stiffness rather than ride height. After fitting, check handling and adjust springs or sway settings on your car if needed to fine tune balance.

Are any modifications required to install?

No permanent modifications are necessary. Use your existing mounting points and standard tools to swap the stock stays for these aluminium parts.

What maintenance should I do after runs?

Clean off grit, check screws remain tight and inspect for deformation. Routine checks keep the parts performing well and prevent damage to mounting holes.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved