TAMIYA Hotshot/Hotshot II Aluminum Stabilizer Stays (Gun Metal) - JR-THS03-GU by Jazrider  [JR-THS03-GU]

Tamiya Hotshot, Hotshot II/2 Aluminum Stabilizer Stay (2pcs) (Gun Metal)
Price:
NZD$8.25
Brand:
JAZRIDER
Model:
JR-THS03-GU
Condition:
Brand New
Available in shop
Write a review

Stabilizer stay specifications and fit

This stabilizer stay set is manufactured for TAMIYA Hotshot and Hotshot II/2 chassis and supplied as two pieces in a gun metal finish. Machined from aluminum, the stays act as an upgrade or direct replacement to influence chassis roll and tuning precision.

Installation is straightforward on compatible Hotshot mount points using the vehicle's existing fittings. Aluminum stays create a firmer anchor than typical plastic options, helping maintain consistent geometry during suspension movement and cornering. After fitting, verify fastener tightness and check for any interference with surrounding links.

Tuning advice: installing aluminum stays will shift front/rear roll balance depending on which positions are changed. Make only small changes and test between adjustments. This product is intended solely for RC chassis maintenance and tuning, not for road vehicles.

How do these stays alter roll balance?

Because aluminum is stiffer than many stock plastics, the stays reduce flex and can change how the chassis rolls; expect a firmer response and adjust anti-roll settings accordingly.

Can I use the original screws to fit them?

Yes, the stays mount to the standard Hotshot points and typically use the vehicle's existing hardware; confirm screw condition and thread engagement during installation.

Should I change one stay or both when tuning?

Start with a single corner if you want to isolate effects, then fit matching stays if a symmetric change is desired; incremental testing gives the best results.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved