TAMIYA Compatible Front Lower Suspension Arm Upgrade for Hotshot/Hotshot II/2/ Boomerang 4WD JR-THS06-LB by Jazrider  [JR-THS06-LB]

Tamiya Hotshot, Hotshot II/2, Boomerang 4WD Aluminum Front Lower Suspension Arms (Blue)
Price:
NZD$27.27
Brand:
JAZRIDER
Model:
JR-THS06-LB
Condition:
Brand New
Available in shop
Write a review

Durable front lower arm for TAMIYA 4WD rigs

This machined aluminum front lower suspension arm is offered as an aftermarket replacement for TAMIYA Hotshot, Hotshot II/2 and Boomerang 4WD chassis. It substitutes the stock plastic component to provide a firmer mounting surface for the front suspension, helping the setup hold alignment under impact and delivering clearer handling cues when tuning.

The component features CNC-style machining and a blue anodized finish consistent with the model code. It is engineered to use the existing chassis mounting points and ball joint locations so installation does not require chassis modification.

Fit this part during routine maintenance, to restore a damaged arm after a collision, or when you want to explore changes to caster and suspension geometry with repeatable results on the compatible models.

Specifications

  • Item: Front lower suspension arm (set)
  • Material: Aluminum
  • Model Number: JR-THS06-LB
  • Compatibility: Tamiya Hotshot, Hotshot II/2, Boomerang 4WD

This precision-milled aluminum arm is aimed at hobbyists seeking reduced flex and stable front-end behaviour across the listed TAMIYA 4WD platforms.

How much tougher is the aluminum arm than stock?

Aluminum offers greater rigidity and impact resistance than the original plastic arm, reducing movement under load and making repeated setup adjustments more consistent.

Does the anodize prevent corrosion?

The blue anodized finish adds a protective layer against oxidation and wear, but normal cleaning and maintenance are still recommended after wet or salty conditions.

Can I tune caster with these arms?

Yes. Because the arm preserves factory ball joint spacing and mounting points, you can experiment with caster and related geometry settings while benefiting from reduced flex.

Will I need different hardware to install?

No special hardware is typically required; the arm is designed to accept the original mounting hardware from the compatible TAMIYA models. Confirm the listing for included fasteners.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved