TAMIYA M03/M04/M05/M06 Universal Drive Shaft M03M-11 by 3Racing  [M03M-11]

Tamiya M03 /M03L /M03M /M04L /M04M /M05 /M06 PRO Universal Shaft - 3RACING M03M-11
Price:
NZD$19.98
Brand:
3Racing
Model:
M03M-11
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Aftermarket shaft for TAMIYA M03 series

The 3Racing M03M-11 is an aftermarket PRO universal shaft compatible with TAMIYA M03, M03L, M03M, M04L, M04M, M05 and M06 RC chassis. It is designed as a direct replacement for stock driveline parts and for scale RC applications.

Verify the chassis code before you buy. Typical replacement steps include removing the wheel hub and driveshaft to access the coupling, swapping the shaft, then confirming alignment and spin-free wheel rotation. Reuse your existing hardware where appropriate and inspect bearings during the job.

For light tuning, upgrading to a PRO shaft can tighten the driveline and improve repeatable power delivery from motor to wheels. During installation, make sure splines engage fully and set screws sit cleanly to prevent binding under load.

Does this replace the OEM shaft directly?

Yes, it is intended as a drop-in replacement for the listed TAMIYA chassis, but always confirm your chassis code before fitting.

What should I check during fitment?

Check spline faces, ensure set screws are tight and free of threadlocker if needed, and spin the assembly to confirm there is no binding before final reassembly.

Will this improve handling?

It can improve throttle feel and reduce drivetrain lash, which helps consistency, but overall handling depends on the whole setup including suspension and tyres.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved