Tamiya M04M Titanium Screw Kit 3RACING TS-M04M/V1  [TS-M04M/V1]

Tamiya M04M Titanium Screw Set - 3RACING TS-M04M/V1
Price:
NZD$38.60
Brand:
3Racing
Model:
TS-M04M/V1
Condition:
Brand New
Write a review

Lightweight Titanium Screws for the Tamiya M04M

Modders searching for a tidy weight reduction will find the 3Racing Titanium Screw Set suits the Tamiya M04M chassis well. These screws replace standard fasteners with a focus on longevity and reduced mass.

Why pick titanium for RC hardware?

Titanium fasteners combine low weight and good strength, which helps lower overall car weight while keeping joints secure during spirited runs. The 3Racing components are made to maintain fit and resist common wear from track use.

Compatibility overview and fitting notes

The kit matches the Tamiya M04M screw points to ensure correct lengths and thread form. Basic hand tools like hex drivers or screwdrivers are sufficient for swapping in the new hardware.

Do these screws need thread locker?

Light duty thread locker can be used on suspension and drivetrain screws if you run on rough surfaces; for body or trim screws it is usually not necessary.

Will titanium threads wear the same as steel?

Titanium is strong but softer than hardened steel in some cases; avoid overtightening and check mating threads for wear when reusing screws.

Can I mix these with stock hardware?

Mixing is possible for selective weight savings, but ensure lengths and thread types match to maintain proper clamping and avoid damage.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved