TAMIYA M-07 Rear Suspension Arm Upgrade (Gun Metal) JR-M705-GU by Jazrider  [JR-M705-GU]

Tamiya M-07 Aluminum Rear Suspension Arms (Gun Metal)
Price:
NZD$15.91NZD$18.72
Brand:
JAZRIDER
Model:
JR-M705-GU
Condition:
Brand New
Available in shop
Write a review

Overview of the Gun Metal Rear Arms

This JR-M705-GU aluminium rear arm set is produced as an aftermarket replacement tailored to the TAMIYA M-07 chassis. The gun metal anodised finish combined with aluminium construction reduces flex compared with stock plastic arms, aiding rear stability when altering setup.

Built to fit the M-07 geometry, the arms accept the original mounting points and hardware for a straightforward swap. By limiting arm flex under load, the upgrade helps make damping and toe adjustments more consistent during setup changes.

Fitment guidance: take off the wheel and free the rear hub carriers if required, then install the aluminium arms with the existing screws and pivot fittings. Confirm pin and bearing engagement and verify full suspension travel before operating the model.

Tuning note: the arm set is a direct hop-up for drivers seeking tighter rear response. Because the change influences shock dynamics and toe behaviour, plan a retune of camber and rebound to achieve your preferred balance of grip and precision.

Are these arms more durable than the stock plastic parts?

Aluminium resists long-term deformation better than plastic, so you should get firmer behaviour under load. However, aluminium can transfer impacts differently, so inspect nearby components after heavy hits.

Do these need special maintenance?

Check bearings and pivot pins regularly, keep threads clean, and re-grease pivot points as part of routine service to maintain fitment and longevity.

Can aluminium arms crack instead of deforming?

Under severe impact aluminium may fracture where plastic would bend. Avoid hard crashes and inspect arms after incidents to ensure safe continued use.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved