Tamiya M08 Graphite Stiffener L for Precision Tuning - Factory Pro O-TCPM01L  [FP-O-TCPM01L]

Price:
NZD$23.63
Brand:
Factory Pro
Model:
FP-O-TCPM01L
Condition:
Brand New
Write a review

M08 graphite stiffener for tuning

This Factory Pro accessory is a graphite chassis stiffener made for Tamiya M08 applications and labelled for 239 use, intended to alter chassis flex without changing suspension geometry.

Its role is purely tuning: by stiffening local sections it changes load transfer between the front and rear, which can sharpen turn-in and stabilise the car at speed for on-road racing. It is designed to mount to the existing M08 fixing points and to complement adjustments to shocks, anti-roll bars and tyre choice.

Installation is suitable for hobbyists comfortable with M08 maintenance; the stiffener fastens to the factory plate areas and typically replaces or supplements stock bracing. Check screw torque and alignment during fitting and inspect surrounding holes and bearings for wear when modifying chassis stiffness.

Model Compatibility

  • Tamiya M08
  • for 239

Does this fit straight onto an M08?

Yes, the part is designed for the M08 mounting layout and is also listed for 239 application as indicated.

How will graphite change handling?

Graphite increases local stiffness, which alters how forces pass through the chassis and typically tightens turn-in while affecting mid corner balance.

Is special hardware required to fit it?

No special hardware is normally needed; use the factory fixing points and standard fasteners, just verify torque settings during install.

Should I check other parts after fitting?

Yes, inspect adjacent screw holes and bearings for wear since altering stiffness changes load paths and can expose weak points.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved